Interface Rate Limit on Juniper EX switches

1. Configure the policer

root@juniperlab# set firewall policer Policer_2M if-exceeding bandwidth-limit 1M
root@juniperlab# set firewall policer Policer_2M if-exceeding burst-size-limit 2k
root@juniperlab# set firewall policer Policer_2M then discard

2. Configure the firewall filter

root@juniperlab# set firewall family ethernet-switching filter Limit term 1 then accept
root@juniperlab# set firewall family ethernet-switching filter Limit term 1 then policer Poicer_2M

3. Apply filter on interface (can be any interface as required)

root@juniperlab# set interface ge-0/0/24.0 family ethernet-switching filter input Limit

Note: Remember that EX series switches apply rate limit only on ingress. 

Comments

Popular posts from this blog

Mikrotik Router OS CAPsMAN Wifi Controller Simple Configuration

Quality of Service scenarios and configuration HP Series 2530 Switches